See any number of posts on the Mach forum about this boardĪnd its many clones.no manufacturer support at all. No that board is Chinese made and is absolute junk, even by comparison to the NVUM. the BIN file can be downloaded from following link on the Novusun web page. Anyway after much searching found BIN file and loaded it all good again. Where do I find this, since the Parent site has nothing like that to download.and the supplier in china Aliexpress (jacky Bulk Man 3d) is Not responding to my email?Īttachment 395826 Attachment 395828 I have had the same problem after six months use started getting load BIN file message. IN my experience a BIN file would most likely be a firmware flash for the Controller card. Ive since tried to reconfiguire the settings and verified, and verified and Now when I launch Mach3 with the Plugin installed and NVUM powered on, its giving me a message about selecting a BIN file If I dont select one it says upgrade failed and continuers to ask for a BIN file. Mark start point, do a toolpath and when it ends and goes back to Home, it was about 12 mm off on the X axis. I configured everything according to manuals and it was acting like it was losing steps. These are wired to the 4 Nema 23 Stepper motor on a CNC build similar to the Workbee. I bought the NVUM v2 Control board in a pakcgae deal with the TB6660 Stepper drivers.
0 Comments
Leave a Reply. |